Material Safety Data Sheet

Product Name: S-168 OPP Adhesive Glue for Dry Laminated Method

1. Identification Of The Substance And Company Information

• Trade Name: OPP Adhesive Glue for Dry Laminated Method
• Product Code: S-168
• Product Class: Thermoplastic Rubber
• Generic Name: OPP Film Laminating Adhesive For Dry Method

2. Hazards Identification

• Health Hazards:
  • Irritating to eyes, respiratory system and skin (R36/37/38)
  • May cause sensitization by skin contact (R43)
• Safety Hazards:
  • Viscous clear liquid
  • Causes mild irritation, suitable protective gear is recommended.
  • Avoid UV light and sunlight to prevent self-polymerization.

3. Composition

4. First Aid Measures

• Inhalation:
  • Remove to fresh air. Consult physician/medical help if respiratory is not relieved by fresh air. Give artificial respiration or oxygen if necessary.
• Eye Contact:
  • Rinse eyes immediately with large amounts of water for at least 15 minutes and contact physician as needed. (S26)
• Skin Contact:
  • Remove contaminated clothing. Wash skin with soap and water. If irritation persists or if contact has been prolonged, obtain medical attention.
• Ingestion:
  • Wash out mouth with water, do not induce vomiting. Consult physician.

5. Fire Fighting Measures

• Fire point and auto-ignition temperature:
  • Fire Point: 25 °C (method: ASTM D92)
  • Auto-Ignition Temperature: Not Available
• Extinguishing Media:
  • Dry Chemical powder, CO₂, foam, sand, Water spray should be used. Never used direct water jet.
• Fire Fighting Instruction:
  • Firemen have to wear full protective clothing with self-contained breathing apparatus to prevent contact with skin and eyes.
  • Evacuate area and fight fire from a safe distance.
  • Hazardous polymerization may occur under fire condition, and toxic fumes may be released.

6. Accidental Release Measures

• Air Release:
  • Reduce vapors with water spray. Stay upwind and keep out of low areas.
• Soil Release:
  • Dig holding area such as lagoon, pond or pit for containment. Dike for later disposal, absorb with sand or other non-combustible material. Collect with absorbent into suitable container.
• Water Release:
  • Absorb with activated carbon. Collect spilled material using mechanical equipment. Cover with absorbent sheets, spill-control pads or pillows. Apply detergents, soaps, alcohols or another surface active agent. Remove trapped material with suction hoses. Subject to California Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65). Keep out of water supplies and sewers.
• Occupational Release:
  • Avoid heat, flames, sparks and other sources of ignition. Stop leak if possible without personal risk. Reduce vapors with water spray. Small spills: Absorb with sand or other non-combustible material. Collect spilled material in appropriate container for disposal. Large spills: Dike for later disposal. Remove sources of ignition. Keep unnecessary people away, isolate hazard area and deny entry. Reportable Quantity (RQ): 1000 pounds. Notify Local Emergency Planning Committee and State Emergency Response Commission for release greater than or equal to RQ (U.S. SARA Section 304). If release occurs in the U.S. and ids reportable under CERCLA Section 103, notify the National Response Center at (800) 421-8802 (USA) or (202) 426-2676 (USA).

7. Handling And Storage

• Handling:
  • General Handling
  • Avoid breathing vapor from container opening.
  • Avoid contact with skin and clothing.
  • Keep container closed.
  • Use with adequate ventilation.
  • Wash thoroughly after handling.
• Storage:
  • Store in a cool dry place.

8. Exposure Controls / Personal Protection

• Exposure Limit:
  • None established.
• Respiratory Protection:
  • If risk of inhalation, wear half-mask respirator with organic vapor canister and built in particulate filter NPF 20 (gas only).
• Eye Protection:
  • Closely fitting goggles.
• Hand Protection:
  • Chemical resistant gloves e.g. neoprene.
• Other Protective Equipment:
  • Wear protective clothing and chemical resistant safety shoes or boots.

9. Physical And Chemical Properties

10. Stability And Reactivity

• Stability:
  • Stable at normal temperatures and pressure.
• Conditions To Avoid:
  • Avoid heat, flames, sparks and other sources of ignition.

11. Toxicological Information

• Oral Rat LD₅₀ > 7800 mg/kg
• PII Value 0

12. Disposal Considerations

• Precautions:
  • Refer to section 7 before handling the product or container.
• Disposal Methods:
  • Recycle or rework if feasible. Incinerate at authorized facility. Landfill in a facility authorized to receive waste. Normally this product need not be considered as a "special waste". However, the relevant authority should be contacted to confirm this statement.

13. Ecological Information

• Unknown

14. Transport Information

• UN No: Not regulated
• LMDG Code: Not listed
• Marine Pollutant: Not listed

15. Regulatory Information

• R-Phrase:
  • Irritating to eyes, respiratory system and skin. (R36/37/38)
  • May cause sensitization by skin contact. (R43)
• S-Phrase:
  • In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. (S26)
  • Do not breathe vapor/mist. (S23)
  • Use only in well ventilated areas. (S51)
  • In case of insufficient ventilation, wear suitable respiratory equipment. (S38)
  • Wear suitable protective clothing, gloves and eye/face protection. (S36/37/38)
  • EINECS: Conforming
  • TSCA: Conforming

16. Other Information

• Prepared By:
  • Company: M. Create International Co., Ltd.
  • Address: No. 31, Alley 12, Lane 261, Sec 2, Xi Yuan Rd, Taipei, Taiwan, R.O.C.
  • Tel: 886-2-2339-2714, Fax: 886-2-2339-5855
  • Name: Hsu Wen-Rong
  • Issue Date: 2009/210
• Notice:
  • Recipients of this Material Safety Data Sheet must make their own assessment of workplace risk as required by other health and safety legislation.
• Liability:
  • The information in this MSDS is correct to the best of our knowledge at the date of publication. It is given in good faith but no warranty is implied with respect to the quality and specification of the product.